JOVS Slimax Microcurrent Anti-aging Device

JOVS Slimax Microcurrent Anti-Aging Device

✓ Triple anti-aging: CET pulses, LLLT light and serums for deep skin renewal.

✓ The 4-step V-shaped facelift targets facial muscles for a sculpted, youthful look.

✓ 18-carat gold nano-rods improve scalp health and hair strength.

✓ 2,500 pulses/s for a soothing and firming body massage.

✓ Ergonomic, cordless and self-disinfecting design for easy and hygienic use.

Golden Pivot 4-step V-shaped facial treatment

11 cm² electric field for rapid reset and soft tissue lifting

Microcurrent technology

Using unique microcurrent electrical pulse waves in conjunction with a membrane to create a high-intensity focused electric film field.

It sends simulated bioelectric currents resembling skin tissue onto the skin, thus treating aging problems such as sagging, drooping, hollowing, loosening, concavity, fine lines and wrinkles.

Specialty fuel

The patented ingredients promote penetration with a penetration-enhancing power of up to 7.65 times.

Our skin carries a negative charge, while the Plussome factor carries a positive charge. The magnetic attraction between them enhances absorption, thus doubling its effectiveness.

How to use

The device is suitable for everyday use.

Note: The EPT mode, when used with a serum, is intended for daily skincare, while in combination with a mask, it is designed for more intensive care.

Avoid using these two modes simultaneously. If necessary, use the daily care mode in the morning and the intensive care mode in the evening.

Face

Preparation: Fixing ring, cotton pad, bottle of collagen essence

1. Cleanse your face thoroughly and make sure it is completely dry.

2. Use the main unit in "S" mode.

3. Place the cotton disc on the head of the device and secure it using the fixing ring.

4. Distribute the essence evenly in the center of the cotton disc, making sure to cover the electrode points well.

5. Press and hold the power button for 2 seconds to turn on the device; EPT mode will activate automatically.

6. Set to a suitable level (for first-time use, levels 1 to 2 are recommended).

7. Begin your skincare routine by following the techniques below. Perform 2 to 3 passes on each side of your face , for a total of 5 minutes . The device will vibrate to indicate that you should return to level 0 at the end of the treatment.

— Slide from the side of the neck towards the shoulder.

— Maintain steady pressure on the shoulder-neck area.

— Apply steady horizontal pressure along the jaw.

— Apply steady horizontal pressure from the corner of your mouth.

— Apply a fixed horizontal pressure to the nasolabial folds (smile lines).

— Apply steady vertical pressure to the side of the cheeks.

— Apply a steady horizontal pressure from the hollow of the under-eye area.

— Apply steady vertical pressure to the temples.

— Apply steady horizontal pressure to the forehead.

8. After use, turn off the device and store it away. Gently pat your cheeks until the essence is fully absorbed, then continue with your usual skincare routine.

Screwing.

1. Cleanse your face thoroughly and make sure it is completely dry.

2. Apply the mask to your face.

3. Keep your hands dry and use the main unit in "S" mode.

Press and hold the power button for 2 seconds to turn on the device; EPT mode will activate automatically.

4. Set to a suitable level (for first-time use, levels 1 to 2 are recommended).

5. Follow the areas and order indicated by the mask to perform 2 to 3 passes on each side of the face , in a total duration of 5 minutes .

The device will emit a vibration to indicate that it is necessary to return to level 0 at the end of the treatment.

6. Turn off the device and put it away.

Continue wearing the mask for another 5 to 10 minutes , then remove it. Gently pat your face to help the essence absorb.

Shoulder and neck

1. Use the main unit in "C" mode.

2. Place the cotton disc on the head of the device and secure it using the fixing ring.

3. Distribute the essence evenly in the center of the cotton disc, making sure to cover the electrode points well.

4. Press and hold the power button for 2 seconds to turn on the device — EPT mode will activate automatically. Then, briefly press the button to switch to SNE mode.

5. Set to a suitable level (for first-time use, levels 1 to 2 are recommended).

6. Apply steady pressure for 8 seconds to each targeted area , then move to the next; repeat twice . The total treatment time is approximately 5 minutes . The device will vibrate to indicate that it should return to level 0 at the end.

7. Turn off the device and store it away. Gently pat the treated area until the essence is completely absorbed.

Note: This same procedure can be applied to other parts of the body to promote relaxation and stress relief.

Head and scalp

1. Use the main unit in "C" mode.

2. Attach the "comb" function head to the working head of the device.

3. Apply essence to moisturize the entire scalp (apply directly to the scalp).

4. Press and hold the power button for 2 seconds to turn on the device — EPT mode will activate automatically. Then, briefly press the button twice to switch to MAS mode.

5. Set to a suitable level (for first-time use, levels 1 to 2 are recommended).

6. Perform a "Z" shaped massage with the comb head to relieve tension in the scalp.

7. The care routine must be completed in 5 minutes , with a reminder vibration to return to level 0.

8. Turn off the device and store it away after use.